Easy to Install and Service By removing one screw, the bottom control box swings down on hinges for complete access to controls and wiring to permit full access for installation, and for cleaning and servicing without dismounting the heater. Isolated terminals allow for Cool 75° C hook-up wire.

Housing Heavy gauge steel with desert tan baked enamel finish. Side panel removeable to gain full access to element and fan area.

Adjustable louvers provide desireable easy air flow adjustments.

Branch Circuit Fusing as standard on All heaters over 48 Amps. Wiring diagram attached to the inside of the control box cover.

Fan Motor Totally enclosued, impedance protected, unit bearing design with high starting and running torques. Fan motor and controls operate directly off of the line voltage of 208 and 240 volt heaters. (on 277 and 480 volt heaters a transformer is built into the unit to provide proper fan motor and control operation.)

Heating Elements Non-glowing design using a bank of tubular captured by Steel plate fins provide uniform heat and extremely long life.

Thermal Cutout is built into the system to automatically shut of heater in event of overheating due to any cause.